• Highly durable, fast curing, water- and solvent-free, 1-component SMP adhesive.
• For laying rubber floor coverings in tiles with rough backings, for suitable PVC - floor coverings (LVT, tiles and panels), for PUR based elastic floor covering in tiles.
• Bonding is carried out on standard-compliant, fully levelled substrates like absorbent and non-absorbent mineral-based subfloors, sanded mastic asphalt, wood composites, dry screeds which are permitted for floor covering installation.
• Special suitable for gluing to wall surfaces.
• Especially for installation areas with higher thermal stress (e.g. conservatories, floor-level window fronts).
• Can also be used in damp areas according to W0-I (DIN 18534) where waterproofing is not required. E.g. outside shower areas without floor drain, guest WCs. **
• Can be used on underfloor heating systems. For high step-sound improvement.
• For indoor use only.
• Contains no migratory components.
• Solvent-free according to TRGS 610 and very low emission laying material, EMICODE EC1 Plus.
• EPD - Environmental Product Declaration declared by IBU 
• Emission-tested construction product according to DIBt principles.

For the laying of:

• vinyl floor coverings in tile and strip format (LVT) (list of flooring manufacturers on request),
• rigid LVT,
• elastomer floor coverings in tile and sheet format,
• elastic floor coverings based on PUR in tile format.

• Among other things, the substrate must have sufficient strength, load-bearing capacity, dimensional stability, be permanently dry and free of cracks.
• ** In areas with water impact classes W1-I, W2-I, normative waterproofing must be carried out on site prior to installation (DIN 19534, ZDB Merkblatt Abdichtung im Verbund).
• Adhesion-reducing layers must be removed by suitable mechanical means.
  In the event of defects, concerns must be reported in writing.
• Cracks or joints (except structural expansion joints) are to be closed with Eurocol Sealing Compound Eurocol 913 Europlan Silicate.
• For levelling the substrate, recommended Eurocol levelling compounds/primers are to be used.
• The installation materials to be used must be suitable for the substrate and the intended use. Primers and levelling compounds are completely set.
• Fixed ceramic and natural stone tiles, concrete ashlar are to be cleaned professionally with Eurocol Basic Cleaner 891 Euroclean Basic and sanded matt after drying.

• Before use, temper the product according to the processing conditions.
• Remove any surface skin that may have formed in the bucket, do not stir in!
• Apply the adhesive evenly to the substrate with a toothed trowel adapted to the installation and the substrate roughness. If necessary, the toothed trowel can be adjusted accordingly in order to achieve sufficient grooved back wetting. 
• On substrates where only very low moisture is to be expected, the floor covering should be laid towards the end of the open time so that the adhesive has as much moisture as possible from the room air available to react.
• Do not press any adhesive between the elements to prevent the adhesive from marking the joints. Immediately rub the laid floor covering with light pressure using a hand roller or cork rubbing board. Re-roll after approx. 1 hour.
• Walkability is delayed for up to two days on dense subfloors, and/or at low humidity levels and/or low temperatures, and/or high adhesive application.

The adhesive has excellent adhesion properties to most types of floor coverings. Due to the large number of manufacturers, adhesion tests must be carried out before application. Please note the positive list for approved floor coverings, which is currently available from
of our application technology.

Processing conditions: 

at least 15 °C floor temperature,
at least 18°C material and room temperature,
50 - 75% relative humidity, recommended <65%.

Recommended primers: