• Ready for use
• Easy to process
• Chemicals-proof
• Scratch-proof
• Extremely good adhesion
• Neutral smell

• The 305 BetonDesign, 395 FloorDesign or 390 FloorColouring must have been created in accordance with the steps described in the instruction manual. The floor must be treated with a coat of 300 BaseCoat first. This coat must be completely dry. BetonDesign walls can be treated directly with 310 FinishCoat.

• Shake well (minimum 1 minute) before use.
• When applying the product to the floor wear shoe covers to prevent foot prints.
• After a base coat of 300 BaseCoat has been applied on the floor, allow at least 2 hours to dry, yet apply the top coat of 310 FinishCoat within 24 hours. Allow a minimum drying time of 12 hours. Apply the system using a 9 mm microfiber paint roller. The coating must be applied evenly and without pressure across the entire surface. We advise that you roll the product in every direction.
• It takes approximately 8 days for the top coat to become resistant. Thus it is important that within these 8 days the floor or wall does not get stained and/or damp, as this may lead to a damaged finishing.
• Fresh product stains should always be removed with water immediately.
• Always consult our technical production information sheets first. When in doubt about the use of the product, please contact our Technical Help Desk.
• Product residues and cleaning water drains according to local applicable environmental rules and do not drain in the sewer.
• Avoid contact with eyes and skin and use proper protecting equipment (see our safety sheet).

Contains benzisothiazolinone. May cause an allergic reaction.

Tips to maintain your BetonDesign and FloorDesign floor:

• For the cleaning and maintaining of BetonDesign floors we advice the use of 312 Conditioner. The protective film ensures that less dirt will attach. In the event of regular use, the look of the floor will be preserved (no shiny effect). Never use chlorine or bleach!
• Provide a proper door mat at the entrance.
• Fit out chair legs with soft protection (e.g. cork or felt), and replace them in time should they become damaged.
• Rolling furniture should be fitted out with soft wheels.

Conditions for processing:
Desired room temperature : 18 - 23 °C
Temperature for material and subfloor : min. 15° – max. 20 °C
Relative humidity : 40 - 70%