• Dispersion based, two-component polymer coat with high cross-linking density for the long-term.
• Hardwearing protection of old and new resilient floor coverings and Eurocol Surface Floors.
• For top-coating of new and re-coating of worn resilient floorcoverings.
  Also for floor coverings, which are exposed to extremely high mechanical and chemical stress.
• Eurocol 322 C Floor creates a wear- and scratch resistant, protection coat with excellent elasticity and chemical resistance.
• Reduced time daily clearning maintenance, reduced for daily dirt adhesion.
• Easy to apply with excellent adhesion.
• Anti-slip classification R9 and R10 with R10 Anti-Slip Additive.
• GISCODE W3/DD+. Very low emission product according to EMICODE EC1 Plus.
• Emission-tested product according to DIBt principles.
• Declared by baubook, "ecological building product".

Reconditioning of resilient floor coverings:

• The surface of the resilient floor- covering which has to be top-coated or re-coated must be clean, dry, free of oil, wax and cleaning residues before coating.
• Therefore the floor surface has to be basic cleaned and evenly, smoothly dry and / or wet sanded using Eurocol Base Cleaner, recommended pads and discs, tools and machines according to Eurocol C Floor instructions or equivalent.
• After complete re-drying of the floor covering, the coating can be applied.

Lacquering of Eurocol Surface floors:

• BetonDesign, LiquidDesign and FloorDesign floors are fully set and vacuumed clean.

• Before use, temper the product according to the processing conditions.
• Please follow our processing conditions advises mentioned above.
• Stir up base coat (component A) in original canister. Empty the container completely into a clean mixing plastic-container, add the hardener (component B) immediately and mix thoroughly with electric mixer for 3 minutes. Allow the mixture to settle for 10 minutes, stir again and use it within 90 minutes (20°C).
• Apply the mixture with Eurocol Eurotool Microfibreroller cross-wise two times within an intermediate drying time of 4 -24 hrs.
• If subsequent coating must be done after 24 hrs the previous coat surface must be fine- sanded with Eurocol Repairpad gray.

For perfect application results:

• Roll out the sealing mixture evenly onto the floor using Eurocol microfiber roller.
• Start application works on the side with the main incidence of light (window side of the room).
• Work away from the light. In this way, it will be possible to keep an eye on the floor during work and enables to correct any application irregularities immediately.
• Apply the sealer by working in sections of a maximum of 1 meter in width at right angles. Apply first layer considering the incidence of light parallel to the window side of the room. Over roll the first layer crosswise this time towards to the direction of the widow light.

The second layer should be applied when the first layer is completely dry.

• Roll the second layer out cross-wise evenly. Avoid the formation of pools/ puddles. Please make sure that there is enough material on the surface!
• To achieve slip resistance Class R10, the Eurocol 872 Aqua Varnish Additive R10 needs to be added to the Eurocol 322 C Floor before adding the hardener. Mix well with slow stirring to homogenize the additive with the A component, then add the hardener and proceed according to the processing instructions of the lacquer.
  The mixture of the additives with the lacquers must be processed within the pot life. Keep stirring the mixture regularly to prevent settling of the structuring during processing.
• 3% of the Eurocol 872 Aqua Varnish Additive R10 must be added to achieve slip resistance R10
  
• During lacquer application wear disposable shoe covers to avoid shoe marks.

Processing conditions: 

at least 15 °C floor temperature,
at least 18°C material and room temperature,
35-75% relative humidity, recommended <65%.