• Non-flammable
• Easy and safe to apply
• Multi-purpose application
• High initial adhesion strength
• Favourable spreading capacity
• Roller-castor-chair resistant 

For installing:

• synthetic backed carpet
• hessian-backed carpet
• needlefelt
• linoleum
• corkment
• vinyl with a back of jute/polyester felt
• cushion vinyl (e.g. Novilon). 

• 444 Euroflex Multi is suitable for any type of subfloor that has a good tensile and compression strength. The subfloor should also be even, clean, permanently dry and free from grease and dirt, according to the requirements of BS 8203 or DIN 18 365.
• Only use pervious floor coverings on impervious subfloors.
• In advance always seek our technical data sheets. In doubt about the application ask for technical advice.

• Apply the adhesive with a regular notched adhesive spreader (Eurocol spreader no. 850/B1).
• On absorbent subfloors apply the floor covering directly into the wet adhesive. On low absorbent subfloors keep a waiting time of approx. 10 minutes.
• Roll the floor covering carefully. Sheet-ends, possible bight marks and longitudinal joints are to be pressed firmly.
• On low absorbent subfloors, in case of impervious back qualities and/or when circumstances are less ideal, rolling and pressing should be repeated after approx. 15 minutes.
• Remove fresh adhesive spots immediately with water.

Working conditions:
Required surrounding temperature : 18° - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 ºC.
Relative humidity : 40 - 80%.

Underfloor heating systems:
444 Euroflex Multi can be applied on underfloor heating systems. The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier. Turn off the heater 24 hours before application. Do not heat again until at least 24 hours after installation, in steps of 5 °C per day.

Contains methylchloroisothiazolinone and  methylisothiazolinone (3:1) and benzisothiazolinone . May produce an allergic reaction.