• Two-component, dispersion-based parquet varnish based on PUR - polyacrylate.
• For use in living areas with intensive use and in commercial use with strongly increased mechanical and chemical stress.
• Wear resistant class C according to Austrian standard ÖNorm C 2354.
• A full structure without primer is possible in many cases.
• For the stressed, hard-wearing, chemical-resistant sealing of all standard-compliant parquet types.
• For interior use.
• The product can be used on underfloor heating.
  
• Emission tested building product according to DIBt principles. 
• Declared by baubook, "ecological building product".

• The surfaces to be sealed must be clean and free of residues of oil, wax, silicone and other adhesion-reducing layers.
• Joints are closed with suitable Eurocol joint sealant. The fine sanding depends on the type of wood. The surface and edge sanding must be levelled out by means of a sanding grid.
• Use a Eurocol primer with barrier effect (e.g. for exotic woods, smoked oak, etc.) or to minimise absorbency and edge gluing (e.g. upright lamella parquet, parquet on sprung floors or on underfloor heating).
• In the case of mosaic parquet or solid wood lamparquet products, installed with Eurocol 1-component parquet adhesives, a full construction is generally required.
• Alternatively in many cases the product can be used as primer and top coat as one.

Before use, temper the product according to the processing conditions.

• Stir before use!
• The hardener LE (component B) has to be added completely to base (component A). Once fully added, stir the mixture for a minimum of 2 minutes until it becomes a homogenous mass. Allow it to react for 10 minutes and briefly shake again
  and homogenize. Add the appropriate lacquer to a mixing container. Use a scraper grid during application.
• Application to be done with a Eurocol stainless double-sided spatula 27 cm or a new, clean Eurocol Aqua microfiber roller 25 cm.
• The application to avoid any footprints on the floor.
• Do not apply more than two roller coats of lacquer in one day.
• Do not use the product after the end of the pot life. End of pot life ist not recognizable by viscosity change!
• To achieve uniform surface, apply the lacquer twice cross-wise or a uniform roller application with subsequent top coat application with roller.
• Eurocol recommends 2-3 roller applications.
• In the same day, do not apply the product more than twice.
• Drying time in-between layers is approx. 3 hours but not more than 24 hours.
• The surface needs to be sanded with an abrasive grid 100 or 120. Remove the dust with an industrial vacuum cleaner.
  Intermediate sanding improves the surface finish. Remove dust remains on the sanded surface.
• During the drying process, even ventilation must be ensured. Draughts and direct sunlight must be avoided.
• Rare woods, bleached ash, acacia, cherry, exotic woods or smoked oak must be primed with a blocking primer because of possible discolouration or streaking caused by ingredients or the smoking process.
  When renovating old floors, please consult our application technology department.

Recommended primers:

Eurocol 883 Europrime Perfect   
Rollable and trowelable, Low side-bonding. High neutrality of the wood tone. Long wet-on-wet workability (rollability). No visible seams during rolling and filling. 
Eurocol 857 Europrime Block     
Exclusively for rolling. Especially for exotic woods, smoked oak and for renovation work. Pronounced accentuation/wood tinting in woods that are sensitive to this, such as oak, beech, etc.

Required surrounding temperature: min. 18°C.
Material and subfloor temperature: min. 15°C.
Relative humidity: 35 - 75%, recommended <65%.