SelectYourLanguage

Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2

eurocol
870 EUROFILLER WOOD

870

Wood filler solution, for joint-filling upt o 2 mm.

870_eurofiller wood_small.jpg
  • pdf-product-specification.pdf

    pdf-product-specification.pdf

  • safety data sheet_eurocol_870_uk.pdf

    safety data sheet_eurocol_870_uk.pdf

Product Typification



Basis : Nitrocellulose dissolved.
Colour : Transparent.
Consistency : Liquid.

Product advantages:
  • Aromatic-free wood filler solution, miscible with sanding dust (grain 80 - 100) of all wood types.
  • For filling joints in fully glued parquet up to 2 mm.
  • Especially for the renovation of old parquet floors and fatty woods.
  • Quick-drying.
  • Transparent setting.
  • Good sanding properties.
  • Before using Eurocol surface materials.
  • For interior use.
  • The product can be used on underfloor heating.
  • Observe the protective information in the safety data sheet!

Performances

Consumption : Approx. 50 - 100 ml/m² depending on the joint width.
Flammability : Highly flammable liquid
Frost resistance : Yes.
Special quality : Quick drying.
Specific weight : 0,8 kg/l

Application

For filling joints in fully glued parquet.

Working Process

Tools : Spatula
Storage : Store cool and dry in unopened packaging.
Shelf Life : Approx 12 months, in unopened packaging. After use close the open packaging well.
Drying : Application with spatula appr. 15 -30 minutes.
Frost-proof : Yes.
Remarks : The technical data sheets and safety data sheets of the other laying materials and parquets used must be observed.
In the case of unknown types of wood, the suitability of the products to be used must be checked by preliminary tests. If the joint edges are very dirty or waxed, adhesion problems may occur.
During the drying process, uniform ventilation must be ensured.
Draughts and direct sunlight must be avoided.
Hazardous material: Observe safety instructions and hazardous material regulations! Eurocol recommends the use of aqueous wood filler solution.

* The mentioned values have been established in our laboratory and must be considered as guidelines in view of possible variations in climatic circumstances, subfloor compositions and layer thickness.

Consumption:
Approx. 50 - 100 ml/m² depending on the joint width.

Substrate:
  • The surfaces to be sealed must be clean and free of residues of oil, wax, silicone and other adhesion-reducing layers.
  • The wood surface is roughly sanded.


User manual:

Before use, temper the product according to the processing conditions.

  • Stir well and thoroughly before use.
  • Mix the solution with approximately 30% of sanding dust of the same wood as the parquet floor (grit: 80 – 120) to an easily applicable paste (consistency similar to dough).

If the consistency of the mixture is too thick, the wood putty mix will not sick well in the joint and may separate while sanding. If the consistency of the mixture is too wet, the joints may not be filled 100%. The finer the sanding dust, the better is the filling ability and the adhesion in the joint.

  • We recommend mixing the solution with sanding dust in a clean bucket to a homogenous mixture and not on the floor! Too much sanding dust can lead to cracks not being filled sufficiently, please reduce the dust quantity.
  • Apply the mixture on the whole parquet floor equally diagonal with a rust free double sided spatula and push the material into the joints forcefully. Repeat the procedure to fill the joints if necessary.
  • After a drying time of approximately. 15 - 30 min., grind the floor find (grit: 100 – 120).
    Make sure that no residues of the wood-putty mixture remain on the surface.

Now you can start sealing the parquet with all types of Eurocol parquet varnishes, parquet oils or parquet oil-waxes.

Processing conditions: 

at least 15 °C floor temperature,
at least 18°C material and room temperature,
35-75% relative humidity, recommended <65%.





Environment and health

GISCODE : G2
Safety and environment : Safety data sheets of Forbo Eurocol products according to EEG-guideline 91/155. Keep out of reach of children. Do not eat, drink or smoke while processing the product. Only give completely empty containers for recycling. Bound material residues can be disposed of as household waste.
MSDS : For extensive information about safety and environment we refer to our website www.eurocol.nl.


Articles

articelproductnamepackagingshipping unit
870Eurofiller Woodtin bucket à 10 l
42/pallet