• Maintenance oil for the care of hand oiled and waxed floors.
• For preserving wood before applying parquet oils/waxes.
• Significantly improves durability, especially in soft woods and in areas subject to heavy wear such as entrances, walking surfaces, doorways.
• Can be used in the contract sector with particularly heavy use.
• Cleans and cares at the same time.
• The product dries colourless.
• The surface is naturally refreshed to match the wood tone.
• For interior use.
• The product can be used on underfloor heating.
• Please check safety data sheet!

• The surfaces to be sealed must be clean and free of residues of oil, wax, silicone and other adhesion-reducing layers.
• Joints are closed with suitable Eurocol joint sealant.
• The fine sanding depends on the type of wood. The surface and edge sanding must be levelled with a sanding grid.
• In order to ensure the penetration of the product, a "tight sanding" of the surface with too fine sanding paper must be prevented.

Before use, temper the product according to the processing conditions.

• Remove any surface skin that may have formed, do not stir in! Stir well before use!

Application as primer oil:

• Coat the sanded and cleaned wooden floor thinly and evenly using a short pile oil-wax-velour roller (4 mm floor). With less absorbent and/or dense woods, the application quantity must be reduced to achieve a stick-free, even drying. In case of doubt, apply several trowel coats instead of roller application until surface protection and uniformity is guaranteed.
• Remove excess oil with a spatula or rubber wiper and immediately massage in under the polishing machine with a beige pad without leaving any residue (1 piece required for approx. 40 - 50 m²).
• If necessary, repeat the process after 12 hours. 

Application for cleaning and refreshing:

• Apply oil locally with a spray can or apply over the entire surface with a weasel. Heavily soiled areas can also be "flooded" with the oil.
• Allow to work in for a few minutes to dissolve the old wax layers and dirt. Now use a cleaning pad (colour depends on the soiling, starting slightly abrasive) to remove the surface, if necessary add oil so that the surface remains wet. Pull together excess and dirty oil with rubber lip and absorb with dry cloths. Then water the cloths!
• If necessary, rework the cleaned surface with clean oil and then level with a white pad while still wet.
• There should be no more shiny spots or oil splashes on the entire surface. Edges, corners, radiators, door reveals, etc., which cannot be reached with the polishing machine, should be rubbed dry with a beige hand pad.
  Avoid excess oil! They dry very slowly and remain sticky for a long time!
• Damaged areas can be repaired after cleaning by re-oiling without sanding the surface.

Working conditions:
Required surrounding temperature: min. 18°C.
Material and subfloor temperature: min. 15°C.
Relative humidity: 35 - 75%, recommended <65%.