colorex
sd signal

Colorex SD Signal enables safe electrostatic discharge through the whole thickness of the tile. The conductive mass throughout the tile is formed by a dense network of tiny carbon black veins. Colorex SD Signal comes in 3 primary colours for identification zones.

A permanently static dissipative floor through the connection between tiles, the conductive adhesive and the connection to earth through a copper strip. Application areas: New build laboratories, ISO cleanrooms, pharmaceutical laboratories, production sites and operating theatres.

SD 150231 sole

Thickness	2 mm
Length x Width	61.5 cm x 61.5 cm
NCS	S 1070-G90Y
LRV	49%
Recycled content	25%
Renewable electricity	100%

ColorexSDsignal

Colorex glued construction

The Colorex collection can be used in many different application areas, because of the different systems and the different levels of conductivity that are offered.

One of the options is to glue Colorex during the installation:
1. directly adhering it to a subfloor
2. bonding it to a raised access floor panel.

When conductive or dissipative properties are required, the connection between the tiles is assured by the conductive adhesive between the tiles and by the copper strip to the earthing point. If Colorex is installed using this process, the static charges are drained to earth via the earthing point.

The Colorex system that can be glued is available in 2 different tile products with ESD properties:
■ Colorex SD – static dissipative tiles of 61,5 x 61,5 cm
■ Colorex EC – electrostatic conductive tiles of 61,5 x 61,5 cm