SelectYourLanguage

Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2

Forbo Websites

Select a division
Forbo Group
Forbo Flooring Systems
Forbo Movement Systems
CONTACT FAQ

eurocol
041 EUROPRIMER EC

041

Current-conducting, ready-to-use primer to replace a very extensive copper strip system on a levelled substrate. As a rule, it will not be necessary to apply and earth more than 1 metre of 801 Eurostrip EC per 30 m². Thanks to EMICODE EC 1PLUS (very low emission) also suitable for BREEAM projects. Suitable for indoor use.

041-europrimer-ec.jpg
  • pdf-product-specification.pdf

    pdf-product-specification.pdf

  • 041-safety data sheet uk.pdf

    041-safety data sheet uk.pdf

  • licence_041 ec_ec1_2020-uk.pdf

    licence_041 ec_ec1_2020-uk.pdf

  • Product Typification
    Static conductive floor primer.
    Basis : Acrylic dispersion. Carbon black.
    Colour : Black.
    Consistency : Thin liquid.

    Product advantages:
    • Non-flammable
    • Favourable spreading capacity
    • Electrical resistance < 3.105 Ohm (EN 13 415) 

  • Performances
    Consumption : 120-150 g/m².
    Electrical resistance : < 3x10 Exp. 5 Ohm, measured in accordance with EN 13 415.
    Flammability : Non-flammable.
    Specific weight : 1.0 kg/l.
  • Application
    • Primer for replacing the copper strip system when installing a conductive floor covering.
    • In combination with conductive floor covering and conductive adhesives an adequate conductivity resistance will be achieved.
    • Normally it is not necessary to apply and earth more than 1 m¹ of 801 Eurostrip EC per 30 m². Provide larger surfaces with a ring pipe, with each section is not larger than 30 m².
    • 041 Europrimer EC is not suitable for application under Nora rubber.  

  • Working Process
    Tools : Lambswool roller or brush.
    Storage : Store cool and free from frost.
    Shelf Life : Approx 12 months, in unopened packaging. After use close the open packaging well.
    Drying : 3-5 hours.*
    Cleaner : Water.
    Sensitive to frost : Yes.
    Remarks : 

    Please pay attention to the technical data sheet and safety data sheet issued by the floor covering manufacturer. Ensure that the levelling under the floor covering is sufficiently thick.041 EC Europrimer reduces the absorbency of the subfloor, therefore, in case of floor coverings that allows the penetration ofwater vapor, allow correspondingly longer drying times for the adhesive.

    EMICODE, for further information see www.emicode.com.


    * The mentioned values have been established in our laboratory and must be considered as guidelines in view of possible variations in climatic circumstances, subfloor compositions and layer thickness.

    Consumption:
    120-150 g/m².

    Substrate:
    • 041 Europrimer EC is suitable for any type of subfloor that has a good tensile and compression strength. The subfloor should also be even, clean, permanently dry and free from grease and dirt, according to the requirements of BS 8203 or DIN 18 365.
    • Under floor coverings it is always necessary to fill with a Eurocol levelling compound, adapted to the intended use, to ensure even and absorbent surfaces.
    • Prime anhydrite floors with 049 Europrimer ABS, thereafter with 041 Europrimer EC.
    • In advance always seek our technical data sheets. In doubt about the application ask for technical advice.


    User manual:
    • Shake the primer well before use. 
    • Apply 041 Europrimer EC evenly and covered with a lambswool roller and/or brush on the entire surface of the subfloor. 
    • Always earth 041 Europrimer EC with 801 Eurostrip EC. Apply on every 30 m² 1 running metre 801 Eurostrip EC and ring pipe. On larger surfaces proportionally more copper strip should be used. The copper strips are to be earthed by an electrician. 
    • Remove fresh spots immediately with water.

    Working conditions:
    Intended surrounding temperature : 18 - 23 °C.
    Temperature for material and subfloor : min. 15° - max. 20 °C.
    Relative humidity : 40 - 70%.





  • Quality and guarantee
  • Environment and health
    GISCODE : D1
    LEED : VOC 0 g/l, meets: IEQ Credit 4.1
    DGNB : VOC 0 %, quality level: 4
    Hazard Class : None.
    Safety and environment : Safety data sheets of Forbo Eurocol products according to EEG-guideline 91/155. Keep out of reach of children. Do not eat, drink or smoke while processing the product. Only give completely empty containers for recycling. Bound material residues can be disposed of as household waste.
    MSDS : For detailed information about the safety measures please refer to the safety information sheet on our website www.forbo-eurocol.de.
    Substances causing allergy : Contains 1,2-benzisothiazol-3(2H)-one, reaction mass of: 5-chloro-2-methyl-4-isothiazolin-3-one [EC no. 247-500-7] and 2-methyl-2H-isothiazol-3-one [EC no. 220-239-6] (3:1). May produce an allergic reaction





  • Articles
    ArticleDefinitionPackagingshipping unit EAN-code
    041Europrimer EC 10 kg jerry can60/pallet8 710345 041010