• High quality, strong, resin-free, Linoleum dispersion-based adhesive
• Very low emission
• Emicode EC 1PLUS
• Non-flammable
• Favourable spreading capacity
• With high initial bonding strength and enhanced open time
• Wet-set adhesive with very fast setting and high adhesion power
• Up to 25 % lower adhesive consumption than market standard products
• Linoleum adhesive, which is characterised by extremely low consumption and therefore leads to a fast re-drying of the installed floor
• The product can be used on underfloor heating
• Suitable for use with chair castors
• Declared by baubook, "ecological building product"
• EPD - Environmental Product Declaration declared by IBU 
• Blue Angel UZ113.

For installation of

• linoleum in sheets and tiles,
• corkment,
• cork, sisal, needle felt and textile floor coverings with different backings, woven carpets,
• vinyl composite floor coverings.

• 611 Eurostar Lino Plus is suitable for any type of subfloor. The substrate must be pressure- and tension-resistant, permanently dry, free of cracks and dust, according to the requirements of BS 8203 or DIN 18 365. Even and free of layers that reduce adhesion.
• Adhesion-reducing layers, old material residues must be removed by suitable mechanical measures.
• When installing on impervious subfloors apply a 2 mm levelling compound layer. For levelling the substrate use recommended Eurocol levelling compounds/primers.
• The installation materials to be used must be suitable for the substrate and the intended use.
• In advance always seek our technical data sheets. In doubt about the application ask for technical advice.

• Before use, temper the product according to the processing conditions.
• Stir before use!
• Apply the adhesive with a regular B1 notched adhesive spreader.
• On absorbent subfloors apply the floor covering directly into the wet adhesive. On low absorbent subfloors keep a waiting time of approx. 10 minutes.
• Roll the floor covering carefully; first widthwise, then lengthwise.
• Do not double-stick bight marks. Lay bight marks into the wet adhesive as usual.
• Sheet-ends, bight marks and longitudinal joints are to be pressed firmly.
• On low absorbent subfloors and/or when circumstances are less ideal, rolling and pressing should be repeated after approx. 15 minutes.
• Remove fresh adhesive spots immediately with water.
• Clean tools with water immediately after use.

Working conditions:
Required surrounding temperature : 18 - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 ºC.
Relative humidity : 35 - 75%.

Further information:

• Keep out of reach of children.
• Keep area thoroughly ventilated during and after processing and drying.
• When processing do not eat, drink or smoke.
• In case of contact with eyes or skin, rinse immediately with plenty of water.
• Do not empty into drains, surface water or onto soil.
• Only hand in packaging without rest material for recycling purposes. Dried rest material can be disposed of as domestic waste.
  

Composition: Acrylic acid copolymers, acrylate dispersion, styrene-butadiene copolymer, thickening, wetting and defoaming agents, mineral filler, water.

Underfloor heating systems:
611 Eurostar Lino Plus can be applied on underfloor heating systems. The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier. Turn off the heater 24 hours before application. Do not heat again until at least 24 hours after installation, in steps of maximum 5 °C water temperature per day.