• Partly plant-based raw materials
• Very low emissions (EC1 plus-certified)
• Reduced environmental impact (renewable raw materials and lower CO₂ emissions)
  
• Non-flammable
• Worker-friendly
• Very easy to apply
• Very economical consumption
• High initial adhesion strength
• Office chair-safe
  

For installation of

• linoleum in sheets and tiles
• linoleum in decorative designs and mosaics
• Corkment
  

• 616 Eurostar Lino Green is suitable for all types of subfloor that are pressure-resistant and tear-resistant. The underfloor must also be flat, clean, permanently dry and free from grease and dirt, in accordance with the requirements of DIN 18 365.
• On completely closed subfloors, apply a levelling layer of at least 2 mm in advance.
• Always consult our technical product information sheets beforehand. In case of doubt about the applications of the product, please contact our Technical Help Desk.
  

• Apply the adhesive with a Eurocol trowel no. 850/toothing B1.
• On absorbent subfloors, place the floor covering directly into the wet adhesive bed. On poorly absorbent subfloors, observe a waiting time of approx. 10 minutes.
• Roll the floor covering carefully, first in the direction of its width and then in the direction of its length.
• Do not grease drying walls on both sides, but place them in the normal adhesive bed (preferably by massaging against the drying wall).
• Press down the front sides, drying walls and longitudinal seams firmly.
• For less absorbent subfloors and/or less ideal conditions, roll and press down again after approx. 15 minutes.
• Remove fresh adhesive spots directly with water.
• Clean tools with water immediately after use.
  

Working conditions:
Required surrounding temperature : 18 - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 ºC.
Relative humidity : 40 - 80%.

Underfloor heating:

616 Eurostar Lino Green can be applied to underfloor heating The underfloor heating startup protocol must be fully implemented in advance according to the supplier’s guidelines. Switch off the heating or switch low one day before application. Switch the heating back on again at least 24 hours after application, in steps of a maximum of 5°C water temperature per day. Ensure that the floor temperature does not exceed 29°C. Make sure that the floor temperature does not exceed 29 °C.

Further information:

• Keep out of reach of children.
• Ventilate the room thoroughly during and after the processing and drying process.
• Do not eat, drink or smoke while processing this product.
• Avoid contact with eyes and skin and use suitable protective equipment.
• In the event of contact with eyes or skin, flush with plenty of water immediately.
• Dispose of product residues and cleaning water in accordance with local environmental regulations and do not dispose of them in the sewer.
• Only return packaging for recycling after removing any residues. Dried material residues can be disposed of in household waste.
• For detailed information about safety measures, please refer to the safety data sheet on our website www.eurocol.nl.
• The product contains 1,2-benzisothiazol-3(2H)-one, a mixture of: 5-chloro-2-methyl-2H-isothiazol-3-one [EC no. 247-500-7] and 2-methyl-2H-isothiazol-3-one [EC no. 220-239-6] (3:1). May cause an allergic reaction.