• Thread-reinforced, double-sided adhesive tape with high and durable adhesive effect and high thermal stability. 
• Can be used for the safe and quick installation of carpet skirtings with both fleece and synthetic secondary backing, of stair profiles, finished steps and floor coverings on steps and risers. Also for the installation of resilient floor coverings on walls. 
  
• On the floor, levelled floor surfaces or fully laid resilient floor coverings, e.g. PVC, linoleum, non-textured, smooth elastomeric coverings, ceramic tiles, terrazzo, wood-based panels or coatings are suitable.
• Skirtings can be effectively pre-coated in the workshop.
• For indoor use.

• The subfloor must be even, permanently dry, pressure-resistant, crack and dust free. Loose adhesions must be removed.
• Minor unevenness or cracks up to 0.5 mm are bridged by the tape and can be evened out with the adhesive.
  Larger unevenness must be levelled out, especially with rigid skirting/profiles. An additional primer is usually not necessary, but is recommended for very rough surfaces.
• When laying on existing floor coverings, e.g. PVC, linoleum, non-textured, smooth elastomeric coverings, ceramic tiles, terrazzo, loosely adhering dirt must be removed with a cleaning agent such as Eurocol 888 Euroclean Uni. For wood-based panels, please contact our application technology department.
• Damaged areas or joints in ceramic tiles and terrazzo must be filled with a stable repair compound, smoothed and primed after drying.
• The smoother and flatter the surface, the better the adhesion. The final adhesion will increase over time.

• Follow the flooring manufacturer's installation instructions. Before use, temper the product and the floor covering to be installed according to the working conditions. 
• If necessary, lay the adhesive tape butt to butt or cut back to butt in case of overlaps. Press firmly, use a cork rubbing board or rubber wall pressure roller! Do not remove the masking paper yet. Roughly adjust the floor coverings, peel off the backing paper in sections and insert the prepared coverings, cut them to size and press on firmly.
  Do not remove any more backing paper, as it can be covered in a short time, do not let it get dirty (dust, do not walk on it).
• When fixing textile coverings in the seam area, the coverings are positioned to fit exactly. Fold back the seam area on one side, mark the joint edge on the floor, fold back the second seam area as well and install the adhesive tape in the middle of the marked seam area and press firmly. Remove masking paper and fold back both coverings and rub them in place. Do not use seam tensioners!
• When pre-coating profiles in the factory and the associated winding of prepared skirting boards/profiles, make sure that the winding tension of the skirting board does not lead to overstretching, which could possibly cause the skirting board to shrink.
• To ensure optimum adhesion, do not subject the glued parts on wall surfaces and in areas of a roller to stress for at least 24 hours. Walking areas can be walked on carefully immediately.

Working conditions: 
At least 18 °C floor temperature, 
At least 18 °C material and room temperature, maximum 30 °C,
50 - 60 % relative humidity.