Design characteristics

• Suitable for both straight and radius conveying
• 57 % open area for excellent air circulation and drainage
• Stainless steel hinge pins for high load capacity, lateral stiffness, less belt supports and minimum belt lifting in curves
• No potential belt edge catch points due to safe fixing of hinge pin

Basic data

S9-57 GRT | 57% Opening | Grid top

• Open area (57 %) for excellent air circulation and drainage
• Lattice-shaped surface

S9-57 NTP | 57% Opening | Nub top (round studs)

• Open area (57 %) for excellent air circulation and drainage
• Lattice-shaped surface with 3.0 mm (0.12 in) high round studs 4 % contact area
• Nub top surface for increased grip and reduced contact area for good release

S9-57 GRT G | 57% Opening | Grid top · guided

• Open area (57 %) for excellent air circulation and drainage
• Lattice-shaped surface
• Guided version (G) allows utilisation
  of the entire belt width

S9-57 NTP G | 57% Opening | Nub top (round studs) · guided

• Open area (57 %) for excellent air circulation and drainage
• With round studs for increased grip (4 % contact area)
• Guided version (G) allows utilisation of the entire belt width

S9-57 GRT F2, F3, F4, F5, F6, F7, F8 | 57% Opening

• Open area (57 %) for excellent air circulation and drainage
• Special edge modules with noses (F2 –F8) of varying size ensure smooth belt operation when the system turn radius is greater than the minimum belt turn radius

Sprockets

in different sizes with round or square sprocket bore

Profiles

in different heights and designs for inclines

Side guards

in different heights for retention of bulk products